Part of Curriculum: Memory and FIFO Design (Module 1: Sequential Design)
View Full Roadmap →
Level 4 Hard 50 pts ✓ Solved

Traffic Light with Pedestrian Crossing

Sequential Design · sequential, fsm

Extend the basic traffic light FSM with a pedestrian crossing button: a press latches a request that cuts the green phase short instead of waiting out the full cycle.

Write a synthesizable Verilog module named top_module matching the ports below exactly.
📐 Circuit Schematic Diagram
NEXT STATECOMBINATIONALSTATE REG[D-FF / CLK]OUTPUTLOGICped_requestlight[1:0]current_state [Feedback Loop]>clk, rst
⚡ Timing & Synthesizability Constraints

Timing Contract: Strict synchronous timing aligned to posedge clk or zero-delay combinational propagation.

RTL Constraints: Synthesizable Verilog-2001. No # delays in synthesizable RTL.

Concept: A latch remembers a pedestrian request across cycles (if(ped_request) ped_latch<=1;) so a single press isn't missed if it doesn't land exactly when checked. The GREEN state then advances to YELLOW as soon as either the latch is set or the normal timer expires — ped_latch || cnt==2 — whichever comes first, then clears the latch on the way out.
NameDirWidthDescription
clkinput1Clock
rstinput1Sync active-high reset (starts at RED)
ped_requestinput1Pedestrian crossing button
lightoutput20=RED, 1=GREEN, 2=YELLOW
walk_signaloutput11 while light is RED
Expected Waveform (Golden Timing Contract)
Verilog-2001 / SV Saved
Font: |
// Click Run Tests (or press Ctrl+Enter) to compile your RTL and simulate against hidden testbenches.
Simulation Timing Diagram (VCD Waveform)
100%
No simulation waveform yet. Run tests to simulate and generate VCD traces.
No compilation run yet. Syntax warnings and elaboration messages will appear here.
No simulation output yet. Raw stdout from vvp will appear here.

RTL Problems / Level 4 · Sequential Design

What You Will Learn

By solving Traffic Light with Pedestrian Crossing, you will acquire core industry skills:

  • Synthesizable hardware modeling in standard Verilog-2001 / SystemVerilog.
  • Correct handling of interface port contracts, edge-triggered clocks, and active-low/high resets.
  • Simulation waveform interpretation and debugging using timing diagrams (VCD traces).
  • Architectural avoidance of timing violations, glitching hazards, and synthesis warnings.

Problem Statement & Requirements

Extend the basic traffic light FSM with a pedestrian crossing button: a press latches a request that cuts the green phase short instead of waiting out the full cycle.

Hardware design teams at leading semiconductor firms evaluate these exact port contracts, race-condition assertions, and corner cases during technical design reviews and ASIC engineer interviews.

Concept: A latch remembers a pedestrian request across cycles (if(ped_request) ped_latch<=1;) so a single press isn't missed if it doesn't land exactly when checked. The GREEN state then advances to YELLOW as soon as either the latch is set or the normal timer expires — ped_latch || cnt==2 — whichever comes first, then clears the latch on the way out.

Port List & Interface Timing

The hidden testbench instantiates top_module. Module port names and bit-widths must match the interface contract exactly:

NameDirWidthDescription
clkinput1Clock
rstinput1Sync active-high reset (starts at RED)
ped_requestinput1Pedestrian crossing button
lightoutput20=RED, 1=GREEN, 2=YELLOW
walk_signaloutput11 while light is RED

Timing Constraints & Synthesizable RTL Rules

⚡ Synthesizable Implementation Guidelines

Timing Contract: Strict synchronous timing aligned to posedge clk or zero-delay combinational propagation.

Synthesis Constraints: Synthesizable Verilog-2001. No # delays in synthesizable RTL.

Starter RTL Code

module top_module(
  input  clk,
  input  rst,
  input  ped_request,
  output [1:0] light,
  output walk_signal
);

  // Your code here — RED(3 cycles) -> GREEN(up to 3 cycles, cut short by ped_request) -> YELLOW(2 cycles) -> repeat.

endmodule
Advertisement

Related RTL Problems in Level 4

Frequently Asked Questions

What does Traffic Light with Pedestrian Crossing require?

Extend the basic traffic light FSM with a pedestrian crossing button: a press latches a request that cuts the green phase short instead of waiting out the full cycle. Implement it as Verilog module top_module matching the listed ports.

Is this design combinational or sequential?

Tags: sequential, fsm. If a clock signal is present in the port table, implement it as sequential logic; otherwise, use continuous assignments or combinational blocks.

How is my solution graded?

A hidden SystemVerilog testbench simulates your module in the cloud judge. You pass when all directed corner cases match the golden model and the VCD timing waveform matches the contract.

How does this challenge help with semiconductor interviews?

Technical interviewers at NVIDIA, Qualcomm, Apple, and Intel routinely ask candidates to code, debug, and explain the timing waveforms of Traffic Light with Pedestrian Crossing to assess real-world synthesizability and race-condition awareness.

Advertisement